Brownsville Custom Pool Pros provides professional pool heaters & heat pumps in Brownsville, TX for residential and commercial properties across the Rio Grande Valley. Pool heater installation in Brownsville is what buys back February, when the water sits at 62 degrees for six weeks and the pool goes unused. An electric heat pump moves heat out of the air rather than burning fuel to make it, and warm, humid Valley air is exactly the condition it works best in. Valley air is exactly what a heat pump wants. We install and service both major types. Gas heaters, natural gas or propane, are the right answer for spas and for anyone who wants the water hot in a few hours rather than a day: high output, fast recovery, higher running cost. Heat pumps are the right answer for holding a pool at a set temperature through spring and fall: slower to bring the water up, dramatically cheaper per degree, and long-lived. Plenty of our customers end up with a heat pump on the pool and a gas heater on the spa, which is the combination that actually gets used. Sizing is not a guess. We calculate BTU requirements from surface area, target temperature rise, wind exposure, and whether the pool has a cover, because an undersized heater runs constantly and never gets there while an oversized gas unit short-cycles and eats its own heat exchanger. Installation includes correct gas line sizing and pressure, proper venting clearances, a bonded and GFCI-protected electrical connection for heat pumps, and integration with the automation system. We also repair what is already there: ignition and flame sensor faults, pressure switch failures, corroded heat exchangers, scaled units where hard Valley water has choked the flow, and the classic no-fire call that turns out to be a plugged filter starving the heater of water. One recommendation that costs nothing: pair any heater with a cover. It is the cheapest BTU you will ever buy.
With 15+ years of experience, our licensed and insured team brings the right materials and equipment to every job — gunite and shotcrete shells, PebbleTec and polished quartz interiors, travertine coping and waterline tile, saltwater chlorine generators, variable-speed pumps, cartridge and DE filtration — and backs the work with a written workmanship warranty. We serve Brownsville and nearby communities including Harlingen, San Benito, Weslaco, Alamo.
What We Handle
Everything our pool heaters & heat pumps in Brownsville covers
One crew, one point of contact, and the full range of pool heaters & heat pumps work in Brownsville, TX. If it is on this list we do it in house rather than handing it to a subcontractor:
- pool heater installation
- natural gas pool heater
- propane pool heater
- electric heat pump pool heater
- spa heater replacement
- pool heater repair
- heater sizing and BTU calculation
- solar pool heating
- pool heater not firing
- heat pump vs gas heater
- commercial pool heating
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Brownsville services.
Materials, equipment and how we do pool heaters & heat pumps
The difference between pool heaters & heat pumps that lasts and pool heaters & heat pumps that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with gunite and shotcrete shells, PebbleTec and polished quartz interiors, travertine coping and waterline tile, saltwater chlorine generators, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Brownsville job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. 15+ years of pool work in the Rio Grande Valley means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do pool heaters & heat pumps outside Brownsville
Brownsville Custom Pool Pros covers Brownsville and the surrounding communities of the Rio Grande Valley. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Pool Heaters & Heat Pumps in Harlingen, TX — Cameron County, population 71,900
- Pool Heaters & Heat Pumps in San Benito, TX — Cameron County, population 24,860
- Pool Heaters & Heat Pumps in Weslaco, TX — Hidalgo County, population 41,100
- Pool Heaters & Heat Pumps in Alamo, TX — Hidalgo County, population 19,000
- Pool Heaters & Heat Pumps in Donna, TX — Hidalgo County, population 16,800
- Pool Heaters & Heat Pumps in Mercedes, TX — Hidalgo County, population 16,260
Start on the Brownsville Custom Pool Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Brownsville Chooses Brownsville Custom Pool Pros
- ✓Over 15 years building and servicing pools across Cameron County
- ✓Residential and commercial — backyard gunite pools to hotel and HOA amenities
- ✓In-house crews from excavation to start-up, not rotating subcontractors
- ✓3D design and an itemized quote before anyone breaks ground
Every pool heaters & heat pumps project in Brownsville gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free pool heaters & heat pumps free estimate in Brownsville, or request a quote and we'll get right back to you.